The following corrections/changes have been made:

Beta 0:
1. Corrected stripping of spaces SSID input.

2. Remove a piece of debug code from the UDP commication (SPI only).

3. When in UDP comminication "R0" will report the same as TCP 
   communication. No data will be returned, not an error message.  

Beta 1: 
Internal release for testing

Beta 3:
1. Corrected when using Direct Connect from the SoftAP (AO) the 
   "C?" command will now report the correct IP address for the
   module.

2. For both the A0 and AD mode of the SoftAP when joining Direct 
   Connect the "[AP DHCP] xxx.xxx.xxx.xxx" message will be sent
   to the host interface. This is consistant with joining any
   other network.

3. The scan probes and dwell time have been increased to find 
   additional active network. Note this release in a slight
   slow down in the complete result being displayed (~1 - 3sec).

4. The default scan for the Soft AP's web page has been reduced
   to the Network Name, Strength, and Security to make the page
   better for small screens.    

Beta 4: 
Internal release for testing
   
Beta 5:
1. Corrected end of messages to match C1.3.4 release

2. AO and AD command will report an error if module is already
   connected to a network or to the SoftAP (A0 or AD modes). 

Beta 6:
1. Corrected F0 to report correct maximum data rate.

2. Correct F0 to report correct RSSI value instead of 999.

Beta 7:
1. Change the timeout for joining (C0 command) from 3000ms
   to 7000ms for routers that need more time to join.

2. Change the default number of retries from 5 to 2.
   Upgraded modules will need to change the number of retries
   using the CB command and saving to flash (Z1 command).

3. Remove some debug message from the C0 command when in 
   command mode ($$$).